7
properly connected to the vehicle and battery. Failure to connect the clamps properly
may cause sparking, an explosion or damage to the unit.
• Always wear eye protection when working with batteries.
• If battery acid comes into contact with eyes, flush the eyes with water for at least
10 minutes. Seek medical attention immediately.
• If skin or clothing comes into contact with battery acid, immediately wash the affected
area with soap and water. Seek medical attention.
• Be sure to remove all metal items (watches, necklaces, rings, etc.) before using the
PowerStation System.
• Always turn the PowerStation System off when not in use. Store in a cool, dry place.
USE AS A 12 VOLT DC PORTABLE POWER SUPPLY
The PowerStation System is equipped with an outlet socket and can be used to operate most
12 volt auto accessories and appliances (11 AMP maximum) equipped with a cigarette
lighter plug. Simply lift up cover on socket and plug in appliance.
NOTE:
socket is live so
appliance will be instantaneously powered. Length of time appliance will operate will
depend on condition of battery and current draw of appliance. Periodically check battery
status during operation and discontinue use immediately if battery condition falls to red
level. Recharge unit as soon as possible and before further use. Power outlet is protected by
an internal circuit breaker to prevent damage to unit in case appliance has a short circuit or
exceeds 11 AMPS. If circuit breaker is tripped, disconnect appliance and have it checked.
Circuit breaker will automatically reset once it cools down (approx. 15-20 minutes).
DO
NOT PLUG A CIGARETTE LIGHTER INTO THE OUTLET OF THE POWERSTATION BATTERY.
OPERATING USB
The PowerStation is equipped with a 2.1A 10W power port. To operate the USB port, plug
adapter in, connect device and push the rocker switch to the USB “•” ON position.
MAINTENANCE INSTRUCTION
S
All batteries lose charge with time. AC recharge is recommended after each use or every
nine months when not in frequent use. Use the AC charger and charge for the recommended
time.
If the unit gets dirty, gently clean the outer surfaces with a soft cloth moistened with a mild
solution of water and detergent. Do not use solvents or other chemical cleaners. Periodically
inspect the condition of charging adapters, connectors, and wires. Replace any components
that may have become worn or broken. These parts are not serviceable. Do not open or
disassemble. Service on PowerStation is confined to replaceable parts only. All other
servicing should be performed by a qualified service technician only.
MOVING AND STORAGE INSTRUCTIONS
Always turn the master switch to the OFF position when not in use.
Store in a cool, dry place.
Fuse Replacement - 12 volt adapter plug
This 12 volt plug is fitted with a 2A fuse in the tip. Should the fuse need replacing, unscrew
end cap and replace with a new 2A fuse.
