OPERATION
5
MAINTENANCE
*Grounded and suitable for outdoor use.
EXTENSION CORD SPECIFICATIONS*
SINGLE UNIT USE • (AWG - American Wire Gauge)
Voltage 25 to 50 ft. 50 to 100 ft.
115/230 16 AWG 14 AWG
After filling the tank with at least
5 gallons of water, lock the front
wheels and connect the power
cord. To turn ON, rotate the power
switch to ON position. For mist,
push on the mist switch. For
sweep, push on the sweep switch.
If the switch is turned to the auto-
shut-off mode, push the mode
START switch to activate. When
tank becomes nearly empty the
unit will shut down.
Sweep adjustments can be easily
made by removing the red thumb
screw, slide the sweep plate to a
different setting and re-install the
red thumb screw.
Flow Control
Valve
Hose
Connector
Power Control Switches
Sweep Adj.
Thumb Screw
Oscillator
Oscillator
Control Box
WARNING! GROUND FAULT
RECEPTACLES ARE RECOMMENDED
AND MAY BE REQUIRED BY LOCAL
AND/OR NATIONAL CODE.
NOTICE! ALWAYS LOCK FRONT
WHEELS BEFORE OPERATION
ASSEMBLY OR SERVICE
Clean Tank
- A slimy tank will create issues! The tank should be rinsed and washed
with mild soap regularly. Do not store or leave water in the tank when out of use.
Clean Sediment Around Pump
- Periodically clean around the pump and check the
in-line strainer.
Inspect Blade Assembly
- Clean the exterior of the blades about once a year or
whenever a film of calcium or mineral deposits is visible. While cleaning, inspect for
irregularities or hairline cracks and replace as necessary.
Storage
- Protect your CoolAire from winter damage. Expansion due to freezing can
burst fittings, pumps and solenoids. If storing unit in below freezing temperatures, be
sure to drain plumbing lines.
