12
Receiver could be connected with up to 5 indicators at the same time.
How to setup receiver:
1.
Press memory button (2) and hold about three seconds until two signals
sounds.
2.
Press button
(4a), to adjust color of pre-set LED according to
indicator.
3.
To confirm correct one press memory button (2).
4.
Move encoding indicator’s roller to activate.
5.
Two sounds confirm encoding finish successfully.
6.
After encoding please check equipment connections working appropriate.
To reset all indicator connections with receiver press and hold memory
button (2) about ten seconds. All setup will be cancelled.
For sets with programmable LED lamp (option)
A
– LED Brightness
B
– LED Duration
C
– Power switch ON/OFF
D
– REGISTER
Replacing the battery: twist off the lamp bottom, take off the lid and
insert 4 AAA 1,5V alkaline battery (not included) observing the correct
polarity and then close the lid. Switch power button ON (C). Beep and
flashing lights confirms lamp is ready to work. After using switch power
OFF (C).
LAMP SETUP
RECEIVER SETUP
