________________________________________________________________________________________________________________________________________________________________
CN3600 Setup & Operation Manual Revision : 6/2020
24
3.3 KNIFE GRINDER
The Knife Sharpening device (with diamond coated grinding wheels located either side
of the knife) (see
Fig. 3-3
) is provided on the machine to maintain a sharp edge when
required.
If unsure where the knife is being ground mark a small section of the knife bevel with a
black marking pen and regrind for a minute. Stop the grinder and check if all the black
mark has been removed. This indicates the bevel is correctly ground and right to the
edge of the knife.
3.3.1 ROUNDING KNIFE EDGE
Operator must wear cut proof gloves when performing this function.
Turn off power at main isolating switch and using a Shielded Oil Stone (see
Fig 3.3.1
) hold
the stone flat against knife ege and slowly rotate the knife with the other gloved hand. This
will have the effect of dulling the sharp edge.
Screen 15 (Sharpening Selector)
Grinding Wheels
IMPORTANT NOTE
If knife is slightly chipped
you will need to retun it to
JAVELIN for repair. The
knife
grinder
on
this
machine is not intended for
heavy grinding.
Fig. 3.3
Fig 3.3.1
