Javad UHFSSRx, Руководство пользователя

Страница: 13 / 23

www.javad.com 13
The built-in user-friendly Command Line Interface (CLI) allows user to perform a full configuration of the unit
and read the statistics and alarm status. It is the most powerful tool to configure the unit. It makes changes to
all possible settings that system will not be able to determine automatically.
The CLI commands allow user to configure and reconfigure the unit’s settings. The user configuration param-
eters that could be changed through the CLI are:
• Data Port Settings
Baud Rate
Data Bits (8, 7)
Parity (Odd, Even, None)
Flow control (None or RTS/CTS)
• Alarm Settings
• Radio Operation Modes
• Sleep modes
On/Off
Activate by internal real-time clock
Activate through RTS/CTS lines
Activate by external sense lines
Activate by any combination of the parameters mentioned before
Note:
The unit’s configuration that is set or modified through the CLI will be lost after unit’s reboot, unless the saving operation
is used to store a new setting in the unit’s configuration file.
The CLI commands also provide filing operations, which include:
• Downloading Unit’s Configuration files
• Software Images
• Uploading Unit’s Configuration files
• Saving into the configuration files the configuration parameters modified through the CLI.
Command Line Interface Convention
The following convention is implemented in HPT435BT Command Line Interface (CLI):
• The Carriage Return/Line Feed (CR/LF, 0x0D/0x0A) is a command delimiter.
• The Carriage Return/Line Feed (CR/LF, 0x0D/0x0A) is a reply delimiter followed by the “CLI>” prompt if
Echo option is On.
• The Carriage Return/Line Feed (CR/LF, 0x0D/0x0A) is a reply delimiter if Echo option is Off (default option).
• The 2-digit number followed by “@” in the unit’s reply indicates the error code (refer to Table 3 for de-
scription), if Echo Off is selected, otherwise the error message is displayed.
• A successfully performed command is replied by @00 code, if Echo Off is selected, otherwise the set value
is replied.
• A command with the certain [Parameter Name] and blank [Parameter List] displays the current settings
for a given parameter.
• To set the mode ordered by CLI commands as permanent User Setting (the setting automatically selected
for the boot-up unit) the SAVE command must be asserted.
COMMAND LINE INTERFACE