Javad Maxor, Руководство пользователя

Страница: 103 / 142

www.javad.com Maxor User’s Manual 4-15
O P E R A T I O N
Changing Receiver Modes
4.
Wait until the STAT and REC LEDs are green
5.
Wait until the STAT and REC LEDs blink orange.
6.
Release the FN key while the STAT and REC LEDs blink orange.
Using PCView to Clear NVRAM
1.
Connect your receiver and computer. See “Connecting the Maxor and a
Computer” on page 2-8 for this procedure.
2.
Click Tools->Clear NVRAM (Figure 4-11).
3.
Click OK at the clear NVRAM confirmation dialog box. The REC LED
rapidly flashes green and red; the STAT LED flashes red.
Figure 4-11. Tools->Clear NVRAM
The receiver will automatically disconnect once the NVRAM is cleared.
Changing Receiver Modes
The Maxor receiver has four modes, two information modes and two power
modes:
• Normal Mode
• Extended Information Mode
• Sleep Mode
• Zero Power Mode
See “Information Modes” on page 4-6 for a description of Normal Mode and
Extended Information Mode.
Sleep Mode
In sleep mode, the power board continues to draw power from the batteries,
causing the batteries to drain over time. Put the receive in Zero Power Mode to
prevent this (see “Zero Power Mode” on page 4-16). Follow these steps to put
the Maxor into sleep mode.