Javad JNSGyro-4T, Руководство оператора

Страница: 36 / 116

2-6 JNSGyro-4T Operator’s Manual www.javad.com
C O N F I G U R A T I O N
JNSGyro-4T Configuration
2
JNSGyro-4T Configuration
PCView is JNS's receiver and board configuration software, used to configure
the boards of the JNSGyro-4T unit. Any settings made using PCView will be
saved in the unit's memory, and will be reflected when you use the MinPad. The
full range of PCView configuration and function is outside the scope of this
manual.
Notice: Refer to the PCView Software Manual to manage all
possible JNSGyro-4T boards configurations.
The following configuration is recommended for the most common
applications. However, you can select configuration parameters as needed for
your particular jobsite.
Notice: Click Apply after making any configuration change,
otherwise the board will not accept the change.
1.
Connect your JNSGyro-4T’s board and computer. See “Connecting the
JNSGyro-4T and a Computer” on page 2-3 for this procedure.
2.
Once connected, start PCView and click on Configuration->Receiver
(Figure 2-5).
Figure 2-5. Configuration->Receiver
The Receiver Configuration dialog box displays (Figure 2-6 on page 2-7).