www.jatontec.com
Header Connection:
Grounding
Make sure that the installation of the outdoor unit, antenna and cables is performed in
accordance with all relevant national and local building and safety codes. Even where grounding
is not mandatory according to applicable regulation and national codes, it is highly recommended
to ensure that the outdoor unit and the antenna mast are grounded and suitable lightning
protection devices are used so as to provide protection against voltage surges and static charges.
In any event, Jaton is not liable for any injury, damage or regulation violations associated with or
caused by installation, grounding or lightning protection.
The Grounding screw is located on the lower part at the back of the unit (see Figure below). Use
10 AWG cable for grounding.
Connect one of a grounding cable to the grounding screw and firmly tighten the grounding screw.
Connect the opposite end of the grounding cable to a good ground(earth) connection.
Connecting to Your Device
JT4200M supports several management interfaces including TELNET, WEB, and TR-069 for
local or remote managements. However normal end user is only provided with WEB based
access.
WEB Login
It is a preferred to setup the CPE using a Web browser from a local PC connected to device LAN
port. The user should ensure that the connected PC have acquired IP address via DHCP from
the device. After IP connectivity is established between the PC and CPE device, the user may
