Jata calor PA1515, Инструкция по эксплуатации

Страница: 13 / 24

13
• If the appliance is fixed to the wall must be placed in
such a way that the plug of the power cord was accessible.
• The fixed installation of this appliance on the wall of a
bathroom always must be done at a distance where no
person in the shower or in the bath may touch it or switch
it on.
• Do not rest the cable on the hot sides of the appliance
and avoid placing it on the air output grid.
• The cleaning and maintenance done by users, can not
be done by children without any supervision.
• If the cable were to deteriorate it must be changed by
an Authorised Service Centre.
LEGS ASSEMBLING
• The legs (3) must be assembled at the ends of the lower part of the appliance.
• To assemble de legs correctly, the mark included in the leg must be always assembled towards the front of the
appliance. Insert the mark into the corresponding hole and screw the legs using the M6 screws.
WALL ASSEMBLING
• Attention: the minimum distances for wall mounting:
From the floor: 20 cm.
From the lateral walls: 15 cm.
• Warning: all objects (table, shelf etc.) must be over the appliance.
• Place the wall supports (4) into the corresponding slots, in the back side of the appliance and screw them.
• To fix the appliance to the wall:
- Make 2 holes in the wall. The distances will vary depending the model you have bought.
Model PA1515: The distance between the middle of the holes is 300 mm.
Model PA2020: The distance between the middle of the holes is 500 mm.
- Insert two pads into the holes and next the two screws.
- Do not insert totally the screws, doing this operation the head of the screw must be separated from the
wall for some millimetres.
- Place the appliance Mekong coincide the supports (4) with the screws.
- Next slide slightly to the left side to leave it correctly fixed.
INSTRUCTIONS OF USE
• Plug the appliance into the mains.
• Turn the thermostat knob (1) clockwise to its maximum position (MAX).
• Select the desired power with the power switches (2).
• When the room reaches the desired temperature, turn the thermostat knob (1) anti-clockwise until the indicator
or indicator lights of the switches switch off which indicates that the thermostat has been disconnected.
• Leave it in that position and the thermostat will maintain the selected temperature with the consequent energy
saving.
• When you do not use the heater, switch off the switches, place the thermostat knob in the off position and
unplug the appliance from the main.