Insert the multi pin plug of the interconnection cable set into
the control cable socket of the welding machine and connect
the other connection into the rear of the wire feed unit
Ensuring that the groove size in the feeding position on the
drive roll matches the contact tip size of the welding torch
and the wire size being used. Release the pressure arm of
the wire feeder to thread the wire through the guide tube,
and into the drive roll groove. Adjust the pressure arm,
ensuring no sliding of the wire. Too high pressure will lead to
wire distortion, which will a
ff
ect wire feeding. Press the wire
inch button to thread the wire out of the torch contact tip.
TIG (Scratch start)
Insert the cable plug with work return clamp into the “+”
socket on the front panel of the welding machine, and
tighten it clockwise.
Insert the cable plug of the valve type TIG torch into the “-”
socket on the front panel of the welding machine, and
tighten it clockwise
Connect the gas hose of the valve type TIG torch to the
cylinder regulator. Open the cylinder valve to check for leaks.
Open the TIG torch valve to set the shield gas flow.
The gas type used for TIG welding is ARGON.
11
