Jasic Arc 200 PFC, Руководство пользователя

Страница: 24 / 46

Page 24
6.12. Wired hand-held remote control (optional)
(Not optional for standard version without remote control interface)
1) Before welding, press the remote-control function key to enable the remote control
function.
2) The indicator will be lit indicating that the remote-control function is enabled. If
the remote controller is connected, the remote controller controls the welding current. If no
remote controller is connected the welding current is controlled by the panel adjuster.
3) The indicator is not on, indicating that the remote-control function is prohibited;
welding current is controlled by the panel adjuster.
6.13. Wireless remote control (optional)
(Not optional for standard version without remote control interface)
1) Wireless pairing connection
Before welding, press and hold the panel remote control function button and the pairing
button of the wireless remote controller at the same time, hold for 2 seconds to
perform wireless remote control pairing. During pairing, the blue indicator of wireless
receiver module flashes, after successful pairing, the indicator of remote control mode
is on . At the same time the blue indicator of wireless receiver module will be
constant on and the welder display window displays "OK".
After successful pairing, the welding current can be adjusted by "+" or "-" buttons on the
wireless remote controller. The range of current is the current the minimum to maximum
current value preset on the panel.
2) Disconnecting the wireless connection: