safety messages to employer
and safety director
Model SEC 400
page 2 of 24
JARVIS
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457--4926
UNITED STATES OF AMERICA E--MAIL.
TEL. 860--347--7271 FAX. 860--347--6978 WWW.
jarvisproducts.com
6204004;.
®
1. Remove
and
repair
any tool that malfunctions. All personnel must be instructed to remove any mal-
functioning equipment.
2. Ensure
that all employees who use this tool are trained in the proper use of this tool and are aware of
the dangers that may arise if they do not follow procedures outlined in this brochure.
3. Ensure
that all employees are instructed not to walk in front of the tool during its use.
4. Enclosed
are four (4) copies of
“NOTICE TO OPERATORS, MAINTENANCE AND CLEANUP
PERSONNEL.”
Post one copy on the employees’ bulletin board; give one copy to the operator(s);
give one copy to the maintenance foreman; and give one copy to the sub--contract cleanup / internal
cleanup foreman.
Additional copies will be provided upon request.
5.
The tool is designed and intended to be powerful. This fact should be obvious to your employees, but
you must emphasize it to them.
6. Ensure
that eye protection is worn in accordance with OSHA’s eye and face protection requirements
(29 CFR 1910.133) when operating tool.
7. Never
make modifications or alterations to the tool.
Replace any missing or illegible labels.
8. Ensure
that proper procedures are established in accordance with OSHA’s lockout/tagout procedures
(29 CFR 1910.147) to prevent accidental startup or release of stored energy.
9. Follow
our installation and maintenance instructions for proper installation and care of the tool.
10. Avoid
injury. Do not permit the tool to be misused.
11. If
you
resell
or
distribute
a Jarvis product, you must provide the purchaser with the appropriate safety
sheets and tool brochure.
Additional copies of safety sheets and tool brochures will be provided upon
request.
SAFETY MESSAGES TO EMPLOYER AND SAFETY DIRECTOR
AVOID INJURY
Keep hands clear.