notice to operators, maintenance
and cleanup personnel
Model SEC 280--4
page 3 of 24
JARVIS
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457-4926
UNITED STATES OF AMERICA
TEL. 860-347-7271
FAX. 860-347-6978
6204009::::
®
NOTICE TO OPERATORS, MAINTENANCE AND CLEANUP PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
1. Disconnect
the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before making any blade changes.
2. Disconnect
the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before performing any repair or maintenance.
3. Disconnect
the power supply - or have the power supply disconnected - in accordance with OSHA’s
lockout/tagout procedures (29 CFR 1910.147) before performing any cleanup.
4. Disconnect
the power supply when the tool is not being used.
5. Always
wear eye protection in accordance with OSHA’s eye and face protection requirements (29 CFR
1910.133) when operating the tool.
6. Never
put fingers, hands or other parts of the body on the cutting edge or within the cutting path of the
tool.
7. Never
allow people to walk in front of the tool during its use.
8. Never
allow people to hold / restrain the carcass while operating the tool.
9. Test
the
tool
prior to use or daily. For models with
dual
anti--tie--down control handles:
Depress
each
trigger separately and the tool should not start.
Depress
one trigger, then pause one second and depress
the other trigger and the tool should not start.
Repeat
this procedure reversing the triggers.
Depress
both triggers simultaneously and the tool should start. With the tool running, release one trigger and
the tool should stop.
Continue
holding the depressed trigger and then depress the other trigger. The
tool should not start. Repeat this procedure holding the other trigger.
For
models with single trigger:
Depress
the trigger and the tool should start.
Release
the trigger and the tool should stop.
If the tool
malfunctions, remove it from service and report or repair it immediately
.
10. Test
the
brake
prior to use and daily. After releasing either or both triggers, the tool should stop within
2.5 seconds.
If the tool malfunctions, remove it from service and report or repair it immediately
.
11. Never
depress the trigger(s) unless you want to use or test the tool.
12. Never
make modifications or alterations to the tool.
Replace any missing or illegible labels.
13. Always
use both hands when starting and operating the tool to avoid the risk of possible “kick back”
or “recoil”.
Continue
holding the tool with both hands until the saw blade comes to a complete stop.
Keep hands clear.
