installation instructions
operation instructions
Model Buster V
page 12 of 16
®
JARVIS
6206002;::::
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457-4926
UNITED STATES OF AMERICA EMAIL.
TEL. 860-347-7271 FAX. 860-347-6978 WWW
.jarvisproducts.com
5 Suspend the Buster V from the balancer.
5.1 Adjust the balancer to the operators’ preference.
6 Adjust the hanger.
Refer to figure 4 for steps 6.1-6.2.
Safety
Kill
Switch
Water
Hookup
Oil Drain
Adjustment “A”
Figure 4
Adjustment “B”
Water Drain
6.1 Adjustment “A”
to adjust the tilt of the saw
:
S
Move hanger bracket (item 2, page 7) toward
the rear of the Buster V to tip the nose of the
saw down.
S
Move the hanger bracket toward the front of
the Buster V to tip the nose of the saw up.
6.2 Adjustment “B”
to adjust the saw to cut straight
down the backbone
:
S
Turn handle (item 7, page 7) clockwise to cut
more to the right.
S
Turn the handle counter-clockwise to cut
more to the left.
7 Attach a cold or warm water hookup.
Refer to figure 4 for steps 7.1-7.2.
7.1 Attach cold or warm water to quick connect plug
(item 24, Figure B, page 5).
7.2 Attach a drain hose
(supplied by customer)
to the
drain coupling (item 27, Figure B, page 5).
OPERATION INSTRUCTIONS
ALWAYS DISCONNECT THE POWER SUPPLY IN
ACCORDANCE WITH OSHA’S LOCKOUT/TAGOUT
PROCEDURES
(29
CFR
1910.147)
BEFORE
PERFORMING ANY MAINTENANCE OR REPAIRS.
1 Turn on the power.
2
Prior to use or daily,
perform the following tests.
2.1 Make sure that the dual anti-tie down control
handles (the top and the rear handles) are work-
ing correctly.
Depress
each trigger separately
and the tool should not start.
Depress
one trigger,
then pause one second and depress the other trig-
ger and the tool should not start.
Repeat
this
procedure reversing the triggers.
Depress
both
triggers simultaneously (within one half second
of each other) and the tool should start. With the
tool running,
release
one trigger and the tool
should stop.
Continue
holding the depressed
trigger and then depress the other trigger. The
tool should not start.
Repeat
this procedure
holding the other trigger.
If the tool malfunc-
tions, remove it from service and report the prob-
lem to your supervisor immediately
.
2.2 Make sure that the Buster V moves freely on its
balancer.
3 Making the cut.
If an elevating platform is used, the operator can keep
the Buster V in a horizontal position during most of
the split.
Always avoid using pressure; instead, guide the Bust-
er V.
Step 3.1 is necessary only during the operators’
learning period.
3.1 Mark the center of the backbone of the beef with
a knife.
3.2 Start the Buster V.
3.3 Saw through the tail bone using the knife mark as
a guide.
