maintenance instructions
Model 1000--FS
page 15 of 16
®
JARVIS
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457--4926
UNITED STATES OF AMERICA
TEL. 860--347--7271 FAX. 860--347--6978
6207001:::
8.6 Slide motor adapter (item 47) off splined shaft
(item 49).
8.7 Remove bearing strip (item 78) and hanger
(item 59).
8.8 Remove o--ring (item 45).
8.9 Loosen set screws (item 50).
8.10 Slide splined shaft (item 49) out of shaft cou-
pling (item 51).
8.11 Remove square key (item 48).
8.12 Remove shaft coupling (item 51).
8.13 Remove hex head screws (item 81).
8.14 Remove motor mounting plate (item 53) and
alignment sleeve (item 52).
8.15 Remove hydraulic motor (item 54).
8.15.1 Pull gently on shaft of hydraulic motor (item
54) and slide motor out of motor housing
(item 77).
8.16 Remove hydraulic motor adapters (item 56).
8.17 Remove o--rings (items 55 and 58) and back--up
ring (item 57).
8.18 Clean and inspect all parts for wear and replace
if necessary.
9 MOTOR HOUSING AND ADAPTER ASSEM-
BLY:
9.1 Reverse steps and procedures outlined in section
8.
See notes below. Refer to section 5 for blade
installati
on
procedures.
9.1.1 Make sure that backup rings (item 57) and
o--rings (item 58) are placed and seated
properly onto hydraulic motor adapters
(item 56).
Refer to Figure 6 below.
9.1.2 Make sure motor end of splined shaft (item
49) aligns and fits properly with square key
(item 48) and shaft coupling (item 51).
9.1.3 Make sure coupling (item 44) aligns and fits
properly with splined shaft (item 49) and
splined end of pinion gear (item 7).
Figure 6
Back--up Ring and
O--ring Installation
O--ring
Back--up Ring
Hydraulic Motor
Adapter
