98
ATTENTION!
If several motors are connected to the same fuse, it is imperative to observe this note!
Disconnecting and reconnecting the power supply (fuse OFF/ON) makes ALL motors
connected to this fuse ready to learn! For this reason, the motors must be disconnect-
ed from the electricity supply by disconnecting the supply line if necessary, in order to
avoid unintentionally re-teaching the hand transmitter to other motors! Observe the
regulations for electrical connection (page 12)!
Changing the direction of rotation of the motor
Option A
1. Press the
programming button
on the motor head for
approx. 3 seconds
.
The motor will vibrate briefly.
The direction of rotation of the motor has changed.
Programming button
Option B
(if the programming button on the motor cannot be accessed).
UP and DOWN
6 x STOP
UP
Current OFF
Current ON
min.
10 sec.
The receiver in the motor is now ready to learn for approx. 5 seconds.
For further programming steps, see the next page
1. Press the
UP
and
DOWN
button on your taught-in transmitter at the same time.
2. Then press the
STOP
button
6x
.
3. Press the
UP
button after the STOP button.
4. Now disconnect the motor from the power supply (fuse off), wait approx. 10 se-
conds, and switch the power supply back on.
EINSTELLUNGEN
SETTINGS / PARAMÈTRES / AJUSTES / IMPOSTAZIONI / INSTELLINGEN /
USTAWIENIA / AYARLAR