Jaroby Volcan B12 TRIDENT, Руководство по установке

Страница: 23 / 25

23
Volcan B12- FOGO
(Check the distance from center to center mounting holes before installation)
1
Tools required: Reciprocating
saw, measuring tape, level,
pencil, eraser, Square tip #2
screwdriver, 6 screws of 1 ½
inches and 4 anchors
2
Mark the starting point
( See figure G )
using the pencil and
measuring tape.
3
Next step are to make a hole in
the wall for the fireplace. Draw
a 36'' inches horizontal line
centered on the starting point
using the level. Draw a point on
each side of the start point at 14
3/4'' inches onto the line you
have just made (see point A and
B on figure G).
4
Draw two vertical line of 21
1/2''inches using your level
starting from the point you have
made at step 3. Make a point on
the ends of these lines (point C
and D). Connect the point C
and D with a line to form a
rectangle. (See figure G)
5
Make a hole on the wall
following the line you have
drawn (Not trough it, only
the side were the fireplace
will be).
6
Starting from both the ends of
the 36'' inches line drawn on
step 3, draw a vertical line
using your level and mark a
point at 12 3/8 and 19 3/8
inches on this line. These
points mark the position of
the anchors (See figure G)
7
Insert the anchors on
these dots.
When in doubt, have it installed by a specialist
8
Secure the 4 screws and
leave 5/16 inches between
the screw head and the
anchors
9
Install the fireplace and
screw
the 2 retaining
screws at there designated
places
( see page 6 ) .