JARLTECH JP8031 series, Руководство по эксплуатации

Страница: 13 / 40

13
Step 6: Confirm RS232 pin assignments
Step 7: Turn on your computer
Please ensure that the RS232 on your computer
conform with the pin assignments of the HOST port on
the Jarltech keyboard:
O
nce all connections are complete, turn on your
computer. It should boot up normally. The key-
board will "beep" three times.
The keyboard is now ready for programming. Turn
to Chapter 3.
Turn off your computer to avoid any accidental damage
to the keyboard. Refer to the keyboard installation shown
in Diagram 2.2.
Unplug the QWERTY keyboard cable from your
computer. Plug the QWERTY keyboard cable into
female side of the Y cable on the Jarltech keyboard
cable. Plug the male end of the Y cable into the key-
board port of your computer.
Once all connections are complete, turn on your
computer. It should boot up normally. The keyboard will
"beep" three times.
The keyboard is now ready for programming. Turn to
Chapter 3.
Programming via the Keyboard Port
Preparation for Programming