LTE910PS v1.00 User Manual JA16-UM
Page 9 Rev: 00 Date: 07/24/19
© Copyright 2019 Janus Remote Communications
Specifications subject to change without notice
All Rights Reserved See website for latest revision. Not intended for life support applications.
4. Configuration continued
CONFIGURATION PARAMETERS
PARAMETER
DEFAULT
RANGE
FUNCTION
Open Switching Interval
900
0-1200
Sets the period that the battery voltage is removed from the
(milliseconds)
telephone line following the termination of a call from the
carrier side, a dialing timeout, or a locally generated busy
tone. (AKA Kewlstart.)
Dialing Tone Timeout
30000
500-60000
Sets time limit for first dialing digit to be entered following going
(milliseconds)
off-hook. Exceeding the time limit will cause Open Switching
Interval to be generated.
Dialing Digit Timeout
6000
250-15000
Sets time limit for time between entering dialing digits.
(milliseconds)
Exceeding the time limit will cause Open Switching Interval to
be generated.
Busy Dwell Timeout
6000
1000-30000
Sets length of time a busy tone is generated locally on calls
(milliseconds)
where the cellular carrier does not provide an audio connection
to a busy tone. The Open Switching
Interval will be generated following the busy tone.
Fixed Format Dialing
0
0-1
Enables Fixed Format dialing. When set to ‘1’ (enabled), only
10 digit (or 11 digits when first digit is a ‘1’) dialing and 911
dialing is allowed.When set to ‘0’ (disabled), any number of
dialed digits is accepted once the Dialing Digit Timeout is
exceeded. Dialing the number sign (‘#’) short-cuts the Dialing
Digit Timeout and immediatly accepts the dialed digits.
Fail Over
0
0-2
Dial tone availability:
0 - Any network availability, including emergency (911) ONLY.
1 - Home network registration
2 - Home or Roaming registration
Inbound Audio Gain
4
1-16
Sets inbound audio gain.
Outbound Audio Gain
4
1-16
Sets outbound audio gain.
D – DEFAULTS Command:
Entering the ‘D’ command will change all of the settings back to the factory defaults. These settings will not be
saved unless the ‘X’ Exit and Save command is issued. Older versions of firmware will request that the POTSwap
be restarted to effect the changes; current versions will restart automatically.
X – EXIT AND SAVE Command:
Entering the ‘X’ command will save any changes made using the ’M’ Modify or ‘D’ Defaults commands. This will
also exit the menu system and requires that the POTSwap be restarted either by pressing the RESET push button
or by un-powering and re-powering the unit.
Q – QUIT AND DISCARD Command:
Entering the ‘Q’ command will discard any changes made using the ’M’ Modify or ‘D’ Defaults commands. This
will also exit the menu system and requires that the POTSwap be restarted either by pressing the RESET push
button or by un-powering and re-powering the unit.
