
3 |
P a g e
Safety
Instructions
Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required.
Do not remove any components or service panels on this product.
Consult Local and National Standards to comply with the following:
o
Health and Safety at Work Legislation
o
BS EN Codes of Practice
o
Fire Precautions
o
IEE Wiring Regulations
o
Building Regulations
DO NOT use jet/pressure washers to clean the appliance.
DO NOT use the appliance outside.
DO NOT store products on top of the appliance
.
Always switch off and disconnect the power supply to the unit before cleaning.
Keep all packaging away from children. Dispose of the packaging in accordance with the
regulations of local authorities.
If the power cord is damaged, it must be replaced by a
Jantex
agent or a recommended qualified
technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience or knowledge, unless they have been
given supervision or instruction concerning the use of the appliance by a person responsible
for
their safety
.
Children should be supervised to ensure that they do not play with the appliance.
This appliance must NOT be installed where persons bathing could reach
.
This appliance must NOT be installed within 1.8M of a wet zone (bath, sink, shower etc)
.
This appliance must NOT be installed where persons could reach when taking a shower
.
DO NOT cover the air inlet
.
Jantex recommend that this product is connected to a circuit protected by an appropriate RCD
(Residual Current Device).
Under no circumstances put a plug on the cable.
Product Description
GD847 -
Jantex
Automatic Hand Dryer - Stainless Steel
Pack Contents
Jantex
Automatic Hand Dryer
Instruction Manual
EN