U N P A C K I N G
6
9)
Gently tilt the speaker up until it is vertical, then further until the feet to
the side with no insert touch the floor.
10)
While continuing to support the speaker, remove the remaining blue foam
insert, and let the speaker down onto all its feet.
11)
Clip the tie that holds the bag shut, and slip the bag partially down.
12)
Place the speaker onto its top by tipping onto its face first, then up onto
its top, remove the bag, and finally turn it back onto its feet.
13)
Remove the protective film from the enclosure.
14)
We advise that you retain all packing materials in case you want to sell or
return the speakers. The cartons can be folded flat, and the inserts can be
interleaved to occupy less space.
Feet
If the speakers were fitted with rubber feet, and you wish to switch over to
carpet spikes:
1)
Lay the speaker onto its face on a carpeted or other soft surface.
2)
Using a #3 Philips screwdriver, remove the screws holding the feet in
place.
3)
Locate the studs in the package of spikes.
4)
Screw the studs into the inserts in the speaker base. The studs have a slot
at one end to facilitate this.
5)
Screw the spikes onto the studs.
6)
If the spikes have been ordered for use on carpeting, as we would advise
to make firm contact with the floor, ensure that the adjustable tips are
screwed in tightly.
7)
If the spikes are for use on hard floors, metal pads are included to avoid
damage to the floor, and the adjustable tips can be used to accommodate
uneven surfaces.
Grills
The speakers are designed to offer optimal sound reproduction with the grills in
place, and they also help protect the electrostatic elements, both from mechanical
damage and from collecting particulates from the air.
The grills are permanently installed. Any attempt to remove them will cause
irreparable damage.