8
MC 9500
Adjusting Needle Drop Position
When the straight stitch is selected on the touch panel, the needle should be positioned in
the center of the needle plate hole.
When the zigzag stitch is selected with the zigzag width set to the maximum (7.0 ), the
clearance between the side of the needle and the edge of hole of the needle plate at the left
and right needle position should be 0.2 mm or more.
2
1
3
4
2
1
3
4
5
5
5
Screw
Zigzag rod
Needle
Needle plate hole
0.2 mm or more
1 Remove the top cover and slect the pattern No. 1 (Straight
stitch).
Lower the needle to its lowest position by turning the
handwheel toward you.
2 Loosen the Screw .
Move the Zigzag rod left or right to set the needle
in the center of the Hole of the needle plate , then
tighten Screw .
3 Select the pattern No.6 (Zigzag).
Set the zigzag width to maximum (7.0).
4 Turn the handwheel toward you to check if the
clearance between the side of the needle and the
edge of the Hole of the needle plate , at the left
and right needle position, is 0.2 mm or more .
5 Attach the top cover.
A = B
2
1
1
4
3
5
4
www.promelectroavtomat.ru
