Janome JW7630, Руководство по обслуживанию

Страница: 35 / 39

33
REPLACING THE ZIGZAG WIDTH MOTOR
TO REMOVE:
1.
Remove the front and rear cover (see page 7 and 8).
2. Remove the two zigzag rod setscrews (B).
3. Remove the two setscrews (C) and remove the zigzag width motor.
TO INSTALL:
4. To install the zigzag width motor, follow the above procedure in reverse.
NOTE
1. The setscrew (B) of zigzag rod should be tightened to 5~7 kg of torque.
2. Check to ensure that the upper shaft sensor mounted on the zigzag width motor does not interfere with the
upper shaft shield plate.
3. Adjust the needle drop position (see page 13).
REPLACING THE ZIGZAG WIDTH MOTOR
2 setscrew (B)
Zigzag rod setscrew (B)
Setscrew (C)
Setscrew (C)
Zigzag width motor
Zigzag width motor