Janome 2030DC, Инструкция

Страница: 33 / 44

31
q
e w
q
r
t
w
r
e
Tacking
q
Stitch pattern: 28
w Thread tension dial: 3 to 6
e Presser foot: Satin stitch foot F
Tacking is used to reinforce pockets, crotches and belt
carriers where extra strength is needed.
• Start sewing
Start the machine and sew until the machine stops
automatically. The machine will sew a tacking 5/8
˝
(1.5 cm) long.
q
5/8 ˝ (1.5 cm)
• Sewing a shorter tack
* Set the speed control slider at low speed setting.
To sew a tack shorter than 5/8 ˝ (1.5 cm), first stop the
machine after sewing the required length w , then press
the reverse stitch button
e
.
The tack length
r
has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
w
Required length
e
Reverse stitch button
r
Tack length
t
Starting point
• Sewing a same-size darning
Simply start the machine to sew another tack at the
same size.
q
e w
Eyelet
q
Stitch pattern: 29
w
Needle thread tension: 1 to 4
e
Presser foot: Satin stitch foot F
The eyelet is used for belt holes etc.
• Starting to sew
Attach the satin stitch foot F.
Start the machine. The machine will stop
automatically when completed.
Open the eyelet with an awl, eyelet punch or pointed
scissors.
w
e
q
• Adjusting the shape of an eyelet
Correct the shape of the eyelet as follows:
Press the cursor buttons to move the cursor under
the value “L3” (default setting)
q
.
If the eylet gap opens
w
, press the button to make
the darn even. (L1–L2)
If the eylet overlaps
e , press button to make the darn
even. (L4–L5)
NOTE:
The shape can be adjusted within L1 to L5 (default
setting is L3).