Page 4
ENGLISH
Jandy
®
Handheld Remote Control Outdoor Transceiver J-Box Assembly | Replacement Kit Instructions
Section 2. Remove Existing
Transceiver J-Box
Assembly
1. Turn off all power to the power center.
2. Open the door to the power center and remove
the dead panel.
3. Disconnect the red four-pin connector from the
red terminal bar located on the power center
PCB (see Figure 1).
4. Disconnect the four conductor wire from the red
four-pin connector. Set aside the red four-pin
connector.
5. Carefully, pull the four conductor wire through
the low voltage raceway and out of the power
center.
6. On the transceiver J-Box, remove the existing
two (2) screws that secure the J-Box to the
mounting surface. Then, remove the transceiver
J-Box from the mounting surface.
Low Voltage
Raceway
Power Center
Air Blower
Handheld Remote
Control Transceiver
J-Box
6'
Minimum 8'
Ground Level
4 Gr
een
3 Y
ellow
2 Black
1 Red
Red 4-Pin
Terminal Bar
Figure 1. Transceiver J-Box Installation
