Jandy CL Versa-Plumb Series, Инструкция по установке и эксплуатации

Страница: 10 / 20

Page 10
Cartridge Pool Filters - CL and CV Series Filters
3.5 Clamp Installation
1. Be certain the o-ring is in position in the lower
WDQNKDOI3UHVVWKH¿OWHUOLGRYHUWKHORZHUKDOI
sandwiching the o-ring between the two halves.
+ROGLQJWKHHQGVRIWKH¿OWHUFODPSDSDUWSRVLWLRQ
WKHKLQJHGVHJPHQWRIWKH¿OWHUFODPSRYHUERWK
XSSHUDQGORZHUWDQNÀDQJHV%ULQJWKHHQGVRIWKH
¿OWHUFODPSWRJHWKHU
3ODFHWKH7QXWDQGWKUHDGHGURGDVVHPEO\LQWR
WKHFODPS%HVXUHWKH7QXWLVVHDWHGLQWKH
clamp in the proper orientation (See Fig. 9).
8VHDVRFNHWRQWKHWLJKWHQLQJQXWXQWLOWKH
clamp ring halves touch each other, or are within
6HH)LJ
but do not overtighten as the
clamp can break . If unable to tighten as indicated,
GRQRWRSHUDWHWKH¿OWHUDQG
call a service
technician immediately .
$IWHUWKH¿UVWZHHNRIRSHUDWLRQFKHFNWKHFODPS
and retighten if necessary.
&KHFNWKH¿OWHUFODPSDWOHDVWRQFHDPRQWK
Figure 9. Filter Clamp Ring
Clamp Ring
"T" Nut and
Threaded Rod
Tightening Nut
w/ Shoulder
&KHFNWKDWWKHGUDLQSOXJIRU&/¿OWHUVRUGUDLQ
FDSIRU&9¿OWHUVLVLQSODFHDQGWLJKW
3. Check that the tank clamp is correctly seated and
tight (See Figs. 9 and 10).
2SHQWKHSXPSKDLUOLQWSRWOLGDQG¿OOWKHSXPS
basket with water to prime the system. Replace the
lid. (You may have to do this several times on new
and seasonal start-ups.)
5. Completely open the air release valve on the
JDXJHDLUUHOHDVHDVVHPEO\E\WXUQLQJWKHNQRERQ
the back of the assembly fully counterclockwise
(do not remove the knob).
%HVXUHWRRSHQDQ\¿OWHULVRODWLRQYDOYHVWKDW
were installed in the system.
7.
6WDQGFOHDURIWKH¿OWHU
and start the pump to
circulate water through the system. When a steady
stream of water starts to come out of the air release
valve, close the valve.
8. Watch the pressure gauge to be sure that the
pressure does not exceed 50 psi (with clean
cartridges). If the pressure approaches 50 psi,
immediately turn the pump off and clean the
¿OWHUFDUWULGJHVVHH6HFWLRQ,IWKHSUHVVXUH
UHPDLQVKLJKDIWHUFOHDQLQJWKH¿OWHUUHIHUWRWKH
troubleshooting guide in Section 8 for possible
causes and solutions.
WARNING
Follow these instructions carefully.
Improper clamp installation can cause
the filter lid to be blown off, which can
result in death, serious personal injury,
or property damage.
CAUTION
DO NOT operate filter at water temperatures above
ƒ)ƒ&:DWHUWHPSHUDWXUHVDERYHWKH
manufacturer's recommendations will shorten the
life span of the filter and void the warranty.
WARNING
NEVER start pump while standing
ZLWKLQILYHIHHWRIWKHILOWHU6WDUWLQJ
the pump while there is pressurized air
in the system can cause the filter lid to
be blown off, which can cause death,
serious personal injury or property
damage.
WARNING
NEVER operate the filter system at
PRUHWKDQSVLRISUHVVXUH2SHUDWLQJ
WKHILOWHUV\VWHPLQH[FHVVRISVLFDQ
cause the filter lid to be blown off, which
can cause death, serious personal injury
or property damage.
Section 4. Start-Up and Operation
NOTE This section applies to both new pool and
seasonal start-up.
1. Turn off the pump. Switch off the circuit breaker
to the pump motor.