Jandy AquaLink RS series, Руководство по устранению неисправностей

Страница: 42 / 48

Page 42
9.2 AquaLink RS Dual Equipment
AUTO
SERVICE
TIME OUT
Mode
Normal operation. Leave the system in
this mode unless you are servicing the
pool or the system. Power Center
buttons (above) do not work.
Mode
In-house Controller is locked out.
Allows manual operation of equipment
using the buttons above. This mode will
stay on until the button is pressed again.
Mode
Allows service person to override all
programs and lock out indoor Controller
for three (3) hours. Any equipment turned on
will remain on, any equipment left off will
remain off.Operation will automatically switch
back to AUTO mode after three (3) hours.
POOL PUMP
SPA PUMP
AUX
POOL SPA HEATER
SOLAR
Button
Turns the Filter Pump on and off.
Button
Turns the Filter Pump on and off.
Buttons
Turns on and off auxiliary equipment
as labeled. AUX 7 socket is the Spa
Pump Relay Socket.
and
Buttons
Turns the heater on and off. The switch
on the heater must be on, the heater
thermostat should be turned to max.,
and the filter pump must be running
for heater to fire.
Button
Activates optional JVA (valve actuator)
plugged into the "solar JVA" socket,
and activates optional relay plugged
into the "solar pump" socket.
System must be in SERVICE or TIME OUT mode for these buttons to operate.
IMPORTANT INSTALLATION INSTRUCTIONS:
1. Installation must be by a qualified electrician and must comply with all national, state, and local codes.
2. Power Center must be mounted at least five (5) feet away from the inside edge of the pool.
3. Install to provide drainage of compartments for electrical components.
4. After wiring, install panels over wiring compartments and keep Power Center door closed.
5. For indoor or outdoor use.
Sheet #7255, Rev. G
AUTO/SERVICE/TIME OUT Button
Pressing this button switches between the
three (3) modes outlined belo
w.
NOTE: Safety Interlocks are not in effect
when service or time mode is active.
AquaLink RS Dual Equipment
(2/6, 2/10, 2/14) Conversion Wiring Diagram
To reduce the risk of injury, do not
permit children to use this product
unless they are closely supervised
at all times. Water temperature in
excess of 100°F/38°C may be
injurious to your health
.
WARNING
AVERTISSEMENT
Pour réduire le risque de blessures,
ne pas permettre aux enfants d’utiliser ce
produit à moins qu’ils soient supervisés
de près en tout temps. Des températures
de l’eau supérieures à 38°C/100°F peu-
vent présenter un danger pour la santé.
CAUTION
Lire la notice technique.
ATTENTION
Read Installation Manual completely
before installing. This product must
be wired in accordance with the
Installation Manual.
6000 Condor Drive • Moorpark, CA USA 93021
707.776.8200 • Fax 707.763.7785
Litho in USA © Jandy Pool Products, Inc. 0711
Pool Low Voltage Heater
Spa Temp Sensor
Freeze/Air Solar Sensor
Pool Temp Sensor
Network Connectors
Connect red four-pin connectors
from Controllers or Remotes
Adjustable Fr Sensor
For technical information, call Jandy Pool Products, Inc., at 707-776-8200, ext. 260.
Red Black Red Black
Red Black
S1
S2
RESET
SERVICE
TIME OUT
FIL
TER PUM
P
AU
X
1
AUX
2
AU
X
3
AU
X
4
AU
X
5
AUX
6
SPA PUMP
AUTO
6 5 4 3 2 1 10 9 8 7 6 5 4 3 2 1 4 3 2 1 4 3 2 1
Red Black Green White Brown Blue Green Black Red Y
ellow
Green Black Red Y
ellow
To Sensors and Heater
(green terminal bar)
To Spa Side
(brown terminal bar)
To Controller
(red terminal bar)
F. Pum
p
Aux. 1 Aux.
2
Aux.
3
Relay Sockets (24 VDC output)
Aux. 4 Aux. 5 Aux. 6 Spa Pump
Cleaner JV
A
Solar Pum
p
Intake JV
A
Return J
VA
Solar
JVA
Spare
Service Controller
Connector
Relay Sockets
(24 VDC output)
JVA Sockets
(24 VAC output)
POOL HEATER SPA HEATER
SOLAR
Spa Heater Interface Board
(Dual Heaters Only)
S1 DIP SWITCH SETTINGS
Factory Setting
OFF
Aux1
1 SPD Filter Pump
Not Used
Cool Down
Normal
Heaters
No Solar
Gas Heater
#
1
2
3
4
5
6
7
8
When Turned
ON
Cleaner
2 SPD Filter Pump
Not Used
Disabled
See Manual
Shared Heater
Solar Installed
Heat Pump
S2 DIP SWITCH SETTINGS
Factory Setting
OFF
Solar Heat Priority
Not Used
Not Used
Not Used
#
1
2
3
4
When Turned
ON
Heat Pump Priority
Not Used
Not Used
Not Used