4.4 Pump Off Delay Variable Timer
When the water is no longer touching the High Water
Sensor, there is a delay before the controller deactivates
the High Water Pump.
The pre-set factory delay time is 20 seconds. See
Table 2, LED Indicators,
and Figure 14.
To change the delay time, follow the steps in
Section
4.5, Change Jumpers and Dip Switches,
refer to Figure
14, and do the following:
1. Slide dip switch S1, which is set for 20 seconds, to
the OFF position.
2. Slide one of the other nine (9) dip switches to the
ON position, depending on the desired length of
the delay.
NOTE Important! There can only be one (1) dip switch
on at any time.
OFF ON 20 sec*
OFF ON 2.5 min
OFF ON 5 min
OFF ON 10 min
OFF ON 15 min
OFF ON 20 min
OFF ON 25 min
OFF ON 30 min
OFF ON 35 min
OFF ON 40 min
S1
S2
S3
S4
S5
S6
S7
S8
S9
S10
*Default is 20 seconds.
NOTE Only one (1) switch can be on at a time.
Figure 14. Pump OFF Delay Dip Switches
4.5 Change Jumpers and Dip Switches
WARNING
Turn off the power to the control box before starting
this procedure. Failure to comply may cause a shock
hazard, resulting in severe personal injury or death.
To change the jumpers and dip switches, do the
following:
1. Shut power off to the control box.
2. Remove the three (3) screws from the upper
cover plate on the front of the control box.
3. Lift and remove the cover plate from the
control box.
4. Locate the jumpers and dip switches. See
Figures 13 and 14.
5. Make adjustments to the jumper(s) and/or dip
switches, as necessary. See
Sections 4.2, Fill
Safety Lockout Mode, 4.3, Pump On Delay
Variable Timer,
and
4.4, Pump Off Delay Variable
Timer.
6. Replace the top cover plate, being careful to align
the LED lights with the plastic lenses in the plate.
7. Install the three (3) screws.
Do not overtighten
or
you will damage the plastic mounts.
8. Turn on the power to the control box. The new
timing changes will take effect.
NOTE If you adjust the jumpers or dip switches without
turning the power off in advance, you will need
to cycle the power from OFF to ON after making
the adjustments for the new timing changes to
take effect.
The dip switches are located below the top left
controller light on the circuit board. See Figure 13.
Page 15
ENGLISH
Jandy Pro Series Levolor
®
II Electronic Water Leveler
Models K-2000
|
Installation and Operation Manual
