J&W nVIDIA NF520LE, Руководство пользователя

Страница: 13 / 42

- 12 -
nVIDIA NF520LE User Manual
2.5 Connecting Peripheral Devices
2.5.1 Floppy and IDE Disk Drive Connectors
The FDD connector connects up to two floppy drives with a 34-wire, 2-connector floppy
cable.Connect the single end at the longer length of ribbon cable to the FDD on the board,
the two connectors on the other end to the floppy disk drives connector. Generally you need
only one floppy disk drive in your system.
2.5.2 Serial ATA Connectors
Each SATA connector serves as one single channel to connect one SATA device by SATA
cable.
2.5.3 PCI and PCI Express slots
Install PCI Express X16 graphics card into slot “PCIE2".
Install PCI Express X1 cards into slot "PCIE1".
Install PCI card into slots “PCI1” 、 “PCI2” or "PCI3" .
Each of the IDE port connects up to two IDE drives
at Ultra ATA 66/100/133 mode by one 40-pin,
80-conductor,and 3-connector Ultra ATA/66 ribbon
cables.
Connect the single end (blue connector) at the longer
length of ribbon cable to the IDE port of this board,
the other two ends (gray and black connector) at the
shorter length of the ribbon cable to the connectors
of your hard drives.
Make sure to configure the “Master” and “Slave” relation
before connecting two drives by one single ribbon cable. The
red line on the ribbon cable must be aligned with pin-1 on
both the IDE port and the hard-drive connector.
The red line on the ribbon cable must be aligned with pin-1 on both the FDD port and the floppy connector.
• eSATA: Connect to peripherial SATA devices.The
peripherial SATA devices must connect inside
SATA connectors. (Optional)