J&M Torsion Flex, Руководство пользователя

Страница: 11 / 37

11
Rolling Basket
Torsion Arms
21/2” x 21/2”
Wing Baskets
Attach the 2’ Light Torsion arms to the rolling basket. Secure
with 1” x 6-1/2” hex bolt and 1” nylon locking hex nut. Fasten
hardware once secured. (Rocker Pads may need installed. Use
4-1/8” x 4-1/2” x 5/8” U-Bolt and (2) 5/8” nylon locking hex
nuts.) Make sure the wing baskets are placed according to the
v.
IMPORTANT: Make sure the wing baskets closest to the
baskets on the Base Unit baskets have a clearance of 2”.
The spacing between each wing baskets should have a
clearance of 1-1/2”.
Attach each torsion arm - rolling basket assembly to the wing.
Secure each torsion arm with (2) 5/8” x 4” x 6” U-bolts and (4)
5/8” centerlock hex nuts.
5/8” x 4” x 6”
U-Bolts
Tire & Wheel Assembly
Wing Arm Weldment
Hydraulic
Cylinder
Wing Arm
Mount
Bracket
1” x 5” Hex Bolt
11/4” x 10” Hex Bolt
1/2” x 6” Hex Bolt
1” x 31/2” Clevis Pin
NOTE:
See “TF212, TF215 with Lift Assist (1 Set of Hoses)” on
page 32 or “TF212, TF215 Equipped with Lift Assist (2 Sets
of Hoses)” on page 34 for correct hydraulic cylinder layout.
Amber Light
Red Light
Rocker Pad
Optional Wing Wheels
Secure the Wing Arm Mount Bracket to the Wing. Place bracket
approximately 6” from the outside of the Wing. Secure using
(2) 1/2” x 6” hex bolts and (2) 1/2” centerlock hex nuts. Fasten
hardware once secured. Attach the Wing Arm Weldment to the
Mount Bracket. Secure with a 1-1/4” x 10” hex bolt and 1-1/4”
nylon locking hex nut. Attach the wheel and tire assembly using
(6) 1/2” wheel nuts.
Align the wheel and hub and tighten the wheel nuts in a star
pattern to 80 Ft. Lbs. Check the wheel nuts periodically to
ensure they remain tight.
Attach the hydraulic cylinder to the Wing Arm Weldment. Secure
with a 1” x 5” hex bolt, 1” nylon locking hex nut, 1” x 3-1/2” clevis
pin, and (2) cotter pins. Fasten hardware once secure. Install the
cylinder lock, fasten with provided lynch pin.
Lights and Light Brackets
Secure both Red Lights to the Main Frame using (4) 1/4” self
tapping screws for each light. Secure both Amber Lights and
Light Brackets to the Main Frame using (4) 1/4” x 5/8” hex bolts
and (4) 1/4” hex nuts per light. Connect all lights to the main
wiring harness. The main harness is installed and located inside
the frame. All remaining wiring needs to be stored inside the
frame.
Setup Instructions