17
IMPORTANT:
Your grain cart has grease fittings at all critical points. The following grease fittings should be serviced before the grain
cart is put into operation:
PTO & DRIVELINE:
The grease fittings on the PTO should be serviced after every 8 hours of use. Service the grease fittings on each of
the drive bearings and also the universal joints after every 8 hours of use.
AUGER ASSEMBLY:
One grease fitting is located on the pivot pin of the folding auger. This fitting should be serviced after every 8 hours
of use. Service the grease fitting on the hanger bushing assembly (top end of the lower auger assembly) as well as the horizontal auger
hangers after every 8 hours of use or as needed.
SPRING LOADED UPPER AUGER BEARING:
Service the grease fitting on the upper auger bearing (located at the top end of the upper
auger assembly) after every 8 hours of use. Lubricate the springs and retaining bolts on the bearing before prolonged storage of the
grain cart.
ROLL TARP U-JOINT:
Service the grease fitting on the U-Joint of the roll tarp crank handle once annually.
Lubrication Service Schedule
Grease Fittings
Pivot Pin
Once Annually
Roll Tarp U-Joint
Once Annually
Upper Auger Flighting
Every 8 hours of use
Driveline
Every 8 hours of use
Horizontal and Vertical Flighting Hangers
Every 8 hours of use
Roll Tarp U-Joint
Drive Line x3
Drive Line x2
Upper Auger Flighting
Pivot
Flighting Hangers
