J&M Corporation ROKKER XXR, Руководство по установке

Страница: 2 / 11

Installation and Instructions
1. Remove the headlight, ignition switch cover, seat, fuel tank, both
saddlebags and both plastic frame side covers to basically strip the
RoadKing down for audio system install. (Photo-A)
Product Description
This exciting new J&M 330w BlueTooth controlled amplifier kit has
been designed specifically for use on the 1998-2017 Harley® RoadK-
ing.
Simply link your SmartPhone to the weatherproof handlebar control-
ler via Bluetooth and control all volume and track up/down music
functions direct from the handlebar buttons.
This is a full range class D audio amplifier and is spec’d at 165watts
RMS per channel X2 channels, (330w total) driven continuous into a
2-ohm load @ 14.4vdc.
Amplifier mounts to the custom made stainless steel bracket system
inside the left saddlebag.
BlueTooth control mounts to the black-powder coated SS handlebar
bracket.
Custom made heavy-duty plug-n-play wiring harnesses are all built at
the J&M factory in Tucson for this specific application, to allow con-
nection to either 2 or 4 total speakers on the RoadKing.
Wiring harness system includes waterproof plugs/pins at each loca-
tion including the left side saddlebag panel connector (like CVO) &
Bluetooth control head connections.
Top quality heavy gauge power/ground wires are used for the fused
battery connection, along with all necessary mounting hardware &
complete installation/operation instructions.
Amplifier itself measures 7 ¼” X 4 ¾” X 1 ¾”.
2. Remove the two bolts holding in the left side fuse
block and pull this fuse block out away from the frame
about 3”. (Photo-B)
3. Begin by placing the long main wiring harness,
behind the main fuse block as a starting point, fishing
the large plug on the one end, behind the frame post
and toward the rear fender/saddlebag position and
secure with tie straps.
(Photo-C)
Photo A
Photo B
Photo C