J&M Wireless 465 Series Helmet Headset Installation Instructions
WARNING!
Helmet speakers may not be legal in all jurisdictions. Check your local laws BEFORE using this product. J & M Corporation cannot control the circumstances surrounding the sale of this equipment, the
quality of installation, or the specific helmet into which this equipment is installed. Accordingly, J & M Corporation makes no warranties, expressed or implied, related thereto. A helmet with this equipment installed
may not protect the user from injury. The user assumes all liability in conjunction with accidents, injuries or losses of any kind arising out of the use of this product. Additionally, this product should not be used in
any way that would impair the user’s ability to hear traffic or other noises. Accordingly, the volume should be kept low or off, depending upon the circumstances.
6C. Installation Instructions For
Shorty Style Helmets
Installation into Shorty Style Helmets
1. Begin by removing the back-clamp from the headset assembly and
replacing it with the provided adhesive backed mounting plate.
2. Install the headset by first inserting the small center tab on the headset
into the back of your helmet between the interior and outer shell of your
helmet.
See Figure 2.
3. Insert the large tab on the left side of the headset into your helmet in
the same manner making sure that the headset is on the inside of the
retention strap on your helmet.
See Figure 3.
4. Repeat this procedure for the right side.
5. Reposition both sides of the headset as necessary so that both speak-
ers are correctly positioned over your ears.
2
Figure
3
Figure
4
Figure
1
Figure
5
Figure
6. Remove the Bluetooth module from the mounting plate/microphone
assembly, then position the mounting plate on the left side of the
helmet so that the microphone lines up with the wearers mouth.
See
Figure 4.
Once the correct position has been determined, clean the
area of the helmet where the mounting plate will be affixed, then peel
the backing from the adhesive mounting tape and install the assembly
on to the helmet. Press firmly for a few moments to make sure the
assembly is securely attached to the helmet. Reinstall the Bluetooth
module on to the mounting-plate/microphone assembly.
7. Complete the installation by routing both helmet straps through the
small retention loops on both sides of the headset.
Install
Remove
