Always disconnect power to the pool light at the circuit breaker panel before attempting
to service the light. Failure to do so could result in serious injury or
WARNING! Risk of electrical shock or electrocution
Do not, under any circumstances, splice wire underwater or behind the light niche during
the installation of this light.
death due to electrical shock. Installation must be performed in accordance with all
applicable federal, state & local installation codes and ordinances by a licensed or
certified electrician or a qualified pool professional. Improper installation may result in
death or serious injury to pool users, installers or others due to electrical shock. In addition,
improper installation may cause property damage.
This device is not intended for use in
anything other than in-ground pools.
PureWhite pool and spa LED lights are operated through the light’s switch. No special
controller or interface is required. Use a junction box to connect and operate multiple
lights with a single switch.
The following steps detail installation of the PureWhite LED light fixture into a new pool
or spa construction. Read this section in its entirety prior to beginning any installation.
WARNING! Important Safety Information for Light Installation
INSTALLER NOTICE:
This light’s external cord cannot be replaced and should be handled
with care. Any damage to this external cord necessitates replacing the light.
INSTALLER NOTICE:
A licensed electrician must complete the following steps prior to
installation of this light in a new pool or spa construction.
WARNING!
Confirm that the pool or spa meets all current National Electrical Code
(N.E.C.) Article 680-22 requirements and any applicable local codes or ordinances. The
pg 2
OPERATION FOR 120VAC AND 12VAC
PUREWHITE POOL AND SPA LED LIGHT FIXTURES
PUREWHITE POOL AND SPA LED LIGHT FIXTURE INSTALLATION
(NEW POOL OR SPA CONSTRUCTION)
