Getting Started
(continued)
XT Series
Quick Start Guide
Page 6
Charging the battery using a Cradle Kit continued:
3. Place the device in cradle. The LED on the device will illuminate to confirm connection.
4. The battery is fully charged in approximately 2 hours.
5. To charge a battery in the spare battery well, insert the battery into the well
top down
(connectors
on the battery should face downward and to the back of the cradle) and gently press down. The LED
light on the cradle will illuminate to confirm connection.
C. ATTACH THE HANDSTRAP
1. Insert plastic fastener on handstrap into the handstrap retainer
face down as shown in diagram. It will click into place.
2. Extend other end of handstrap toward base of XT Series
unit (rough side of Velcro should be facing up). Feed
through the handstrap bar as shown in diagram.
3. Pull handstrap through handstrap bar and fasten Velcro
to close the strap. Fit strap and secure device to user’s
hand by adjusting Velcro as needed.
D. REMOVE THE BATTERY
1. Push the battery lock switch to the unlock position by sliding it to the right.
2. Lift the battery at the upper right corner (finger lift groove marked by an arrow).
E. ACCESS SIM CARD SLOT AND MICRO SD CARD SLOT
1. After removing the battery, lift the media card compartment cover using notch at the top (it drops
down to open).
2. To access the SIM card slot, slide silver SIM card cover to the left and lift open.
3. To access the microSD card slot, slide silver microSD card cover to the left and lift open.
