XM60+ User Guide
2-
2
Janam Technologies LLC
Attach the handstrap
1.
To attach the handstrap, first align the two holes in the metal handstrap anchor at the two handstrap
screw ports. Then, for each side, place one of the screws provided into a lined up screw hole/screw port
and turn clockwise. Secure both sides before fully tightening down the screws.
2.
Separate velcro to extend the handstrap and feed loose end through the handstrap bar. Fasten velcro
together to close the strap. Fit strap and secure device to user’s hand by adjusting velcro as needed.
Install the battery
IMPORTANT Battery Warning!
CAUTION: Use only Janam-approved batteries.
There is the risk of explosion if battery is replaced by an incorrect type.
Always dispose of used batteries according to the instructions.
1. To access the battery compartment, turn the battery screw counterclockwise to open the latch
and remove battery cover.
2. Position the battery lift strap against the back of battery well, ensuring tab extension is on left side.
3. Place a Janam Lithium-ion rechargeable battery in and snap into place.
4. Replace the battery cover by positioning the top prongs first and sliding into place. Tighten battery
screw by turning clockwise.
To charge the battery:
To charge the battery using the USB Cable or Serial Cable:
1. Connect the power supply to the USB cable or serial cable.
2. Connect snap-on end of USB cable or serial cable to bottom of XM60+, making sure the word TOP on
the cable connector faces front.
3. Insert country-specific AC plug, and plug in the power supply.
4. The LED will illuminate to confirm connection (orange indicates charging, green indicates fully charged
and red indicates fault).
5. The battery is fully charged in approximately two hours.
To charge the battery using the Single-Slot or Four-Slot Cradle:
1. Connect the power supply to the cradle.
2. Connect the line cord to the appropriate power supply.
3.
Plug
in
the
power
supply
.
4.
Insert
the
XM60+
into
the
cradle.
5. The LED will illuminate to confirm connection (orange indicates charging, green indicates fully charged
and red indicates fault).
6. The battery is fully charged in approximately two hours.
L
I
M P O R T A N T N O T E
!
The
main
battery
charges
the
backup
battery
in
the
XM60+
unit.
When
the
main
battery
is
fully
charged,
do
not
remove
it
from
the
unit
for
24
hours.
If
the
battery
is
removed
during
this
period,
the
device
cannot
maintain
any
user
data.
