Janam XM60, Быстрый старт

Страница: 6 / 13

A. INSTALLING THE BATTERY
1. To access the battery compartment, turn the battery screw counterclockwise to open the latch and
remove battery cover.
2. Position the battery-lift strap, place the Lithium-ion battery and snap into place.
3. Replace the battery cover by positioning the top prongs fi rst and sliding cover into place.
Tighten battery screw by turning clockwise.
B. CHARGING THE BATTERY
Important Note: The main battery charges the backup battery in the XM Series unit. Once the main battery is
fully charged, do not remove it from the unit for 24 hours. During this period the device cannot maintain any
user data if the battery is removed.
To charge the battery using the USB Synching/Charging Cable or Serial Synching/Charging Cable:
a. Connect the power supply to the USB or Serial Synching/Charging cable.
b. Connect snap-on end of USB or Serial Synching/Charging cable to bottom of device making sure the
word “TOP” on the connector faces front.
c. Insert appropriate AC plug and plug in the power supply. Use only easily accessible wall outlets that are
easily reached with the length of supplied power cable.
To charge the battery using the Single-Slot or Four-Slot Cradle:
a. Connect the power supply to the cradle.
b. Connect the line cord to the power supply.
c. Insert appropriate AC plug and plug in the power supply. Use only easily accessible wall outlets that are
easily reached with the length of supplied power cable.
d. Place the XM device in cradle. The LED will illuminate to confi rm connection (orange indicates charging,
green indicates fully charged and red indicates fault).
e. The battery is fully charged in approximately 2 hours.
f. Charge a spare battery by placing the battery in the spare battery well with label up and connectors lined up.
Installing and Charging the Battery
Page 5 XM Series Quick Start Guide