JAMO D 8ADD, Руководство пользователя

Страница: 14 / 15

6
GB
Bi-amping (D 8CEN)
In bi-amping the loudspeakers are connected to two power amplifiers.
Here you have two options:
1. Connect amplifier “1” to the tweeter/midrange.
Connect amplifier “2” to the woofer.
(When different amplifiers are used).
- or -
2. The two amplifiers are used for the left and right channels, respectively, i.e. the tweeter/midrange units are connected to one
channel on the amplifier, and the woofer is connected to the other. (Typically when identical amplifiers are used)
Consult your Jamo dealer for further information.
Always make sure that the loudspeakers are in proper phase;
The + terminal on the loudspeaker is connected to the + terminal on the amplifier.
The - terminal on the loudspeaker is connected to the - terminal on the amplifier.
Loudspeaker cable is usually marked on one cord; this cord is normally used to connect the + terminals, this way it is easy to ensure that
the loudspeakers are in correct phase.
Connecting
Jamo D 8 is equipped with gold-plated terminals which will accept heavy stripped cables. Your local Jamo dealer can advise you on
which cables to buy. In general, the longer the cable, the higher quality should be used to avoid signal loss in the cable itself. In terms of
sound quality it is therefore an advantage not to use cables which are longer than required, although the cables used to connect each of
the speakers should be roughly the same length.
Single wiring / Bi-wiring (D 8CEN)
If you wish to use cables with stripped ends, proceed as follows
1. Turn off the amplifier.
2. Gently strip off approximately 15 mm of the insulation on
the cable ends - be careful not to damage the cable wires.
3. Twist the wires.
4. Turn the terminal screws counterclockwise until the twisted
wires can easily be inserted into the holes.
5. Turn the terminal screws clockwise to secure the cables in
the terminals.
NOTE:
Verify that the wires from the + and - cables do not touch
each other, as a short-circuit could damage the amplifier’s
output stage.
If you wish to connect each speaker with a single cable,
the supplied “bridges” should remain fitted between
the two sets of terminals.
The loudspeaker comes from Jamo with the “bridges”
fitted for single-wiring.
If you are using bi-wiring, remove the “bridges” between
the two sets of terminals.
You can connect the cables together to one set of output
terminals on the amplifier, or, if the amplifier has two
sets of output terminals, connect one cable to terminal
set “A” and the other cable to terminal set “B”.
1
2
All manuals and user guides at all-guides.com