JAMO 250 Скачать руководство пользователя страница 5

Electronics 

The important things on subwoofer amplifiers are the ability to deliver high 
power – especially peak burst are important to reproduce e.g. an explosion or a 
bass drum with full fidelity. This has to be done with a minimum of distortion 
and a very tight control of the woofer.

 

Due to the nature of a normal class AB amplifier we would need to have a very 
big power supply since only approx 60% of the power is turned into sound – 
the rest is turned into heat. Consequently the heatsinks of these amplifiers 
would also have to be enormous in order to cool the amplifiers sufficiently. 
On the other hand a class AB amplifier has some excellent qualities – such as 
musicality, low distortion and high damping factor. 
So, if we could combine these qualities with the efficiency of a Class D amplifier 
it would be ideal . . . 
 
Consequently, the development team turned to a specialized technology that 
matched our demands perfectly: High power output with high efficiency while 
maintaining musicality, low distortion and tight control of the woofer. A 
patented technology called BASH®.  
 
The key idea of the BASH technology is based on a continually variable supply 
voltage which tends to zero when there is no input signal and reaches its 
highest level when the amplification requires power. This supply voltage is 
continuously variable but always lower than that of an AB class amplifier and 
thus a much higher efficiency is achieved.  
 
The outstanding energy efficiency (85%) achieved by this technology, allows 
very high output power, without heating up the amplifier and thus elimination 
of the need for excessive heat sinks. 
 
The power supply itself uses a high speed D class unit in order to constantly 
supply the amplifier with the appropriate power.  
 
Due to its voltage switching capability a BASH amplifier plays louder than a 
conventional amplifier of comparable RMS power. Simply by not being a 
voltage limited amplifier it has tremendous dynamic power capability. 
 

Controls & Features 

All the subwoofers features volume-, variable phase- and variable cut off 
frequency controls to make sure that the sound from the subwoofers can be 
adjusted to blend in seamlessly with the sound from the rest of the speakers. 
SUB 650 also features a 12V trigger input, so it can be turned on and off from a 
A/V receiver/controller that has a 12V output, ensuring that the subwoofer 
always will be active when the A/V receiver/controller is turned on. 

 

Содержание 250










Отзывы: