•
Once you have selected a pre-authorization amount, Follow the steps
below to use your credit card.
•
To
pay with your phone or to use a prox card
, simply hold it close to
the center icon when prompted to pay. Leave the phone or prox card in
place until the reader’s display shows approved.
•
To
pay with a mag stripe card
that does
not have a chip or has a chip that the reader
can not read, use the credit card swipe on
the right side of the reader. Swipe the card
in a downward direction with the magnetic
strip on the bottom and facing the card
reader.
•
To
pay with a chip card
, insert it in the
lower slot with the chip facing up and
inserting the end with the chip first. Be sure
the card is pushed all the way in.
•
The reader’s display will inform you to
remove your card once successfully read.
The screen will show if your card was
approved or if there was an error. You
will be instructed what to do next. For
example, If there was an issue reading
the chip, you may be prompted to try
again or use the card swipe instead.
Attention:
There is a "Minimum Transaction" amount of $0.10 but this
can be set higher by the administrator. If the cost of your job is lower
than the minimum, you are still charged the minimum amount.
For example:
If the "Minimum Charge" is set to 25 cents and the
transaction is ended after only making one 10 cent copy, You will be
charged the 25 cent minimum. Once over the minimum, the amount
charged will reflect the actual job cost of 10 cents per page. Therefore it
may not economical to use a credit card to pay for small copy or print
jobs that would cost less than the minimum value.
6
