If the stopwatch hands are not in the [
0
] position
(12 o’ clock position), follow the procedure below to
set them to the [
0
] position.
If the stopwatch is in use, press the buttons in the
following order to reset, and then, check if the
hands return to [
0
] position.
• If the stopwatch is counting:
A -> B
• If the stopwatch is stopped:
B
If either of the stopwatch hands are not in the [
0
]
position, reset them following the procedure below.
1. Unscrew the crown and pull it out to position[
3
] .
2. Press button
A
or
B
to reset all stopwatch hands
to [
0
] position.
*
The stopwatch minute hand moves corresponding-
ly with the stopwatch second hand.
Tips:
The hands move quickly if the respective
buttons are kept pressed.
3. Push the crown in and screw it securely.
8
WATER RESISTANCE
Note that the water resistance chart serves only as a
guide (please refer to the water resistance chart on the
next page). Actual water resistance may vary depending
on a number of factors including water temperature,
water salinity, and use under water.
The water resistance of your timepiece may eventually
be compromised over time with general wear and tear
and use of your timepiece under adverse conditions.
Always remember to employ the screw down crown if
available to maintain the water resistance of your
timepiece. Warranty may be voided if the screw down
crown has not been properly employed.
Note that you should
never
wear your watch in a jacuzzi
or steam room where steam may enter the case despite
the water tight seals used to protect your watch. This
may cause condensation inside your watch which may
effect and damage the inner workings of your watch.
