Jamara E-Rix 450, Инструкция по эксплуатации

Страница: 7 / 20

7
Starting up
The installed gyro is a mini gyro and therefore the setting buttons
are very small. Be very careful when adjusting settings on the gyro
and use an adequate screw driver.
1.
Connect the gyro to the rear rudder channel you will later control
on our transmitter. The other plug should be connected to the
cable for the receiver exit which controls the delay time. Connect
the servo to the exit point of the gyro.
2.
Switch settings
The ‚DS’ switch will enable you to adjust the servo to the gyro. For
digital servos, please switch the ‚DS’ button to ‚ON’. For analogue
servos use ‘OFF’
The ’NOR/REV’ switch will enable to adjust the direction of action.
It will adjust the turning direction of the rear rotor servo.
NOR = normal turning direction
REV = reveresed turning direction
If you notice that the turning direction of the servo is the opposite
way, adjust by unsing the ’NOR/REV’ switch. In addition, make sure
the gyro is working correctly by
checking the manual of the gyro.
3. Servo deflexion (limited)
The maximum servo deflexion can
be programmed by the controller
without setting it by the transmitter.
• With an increase of the setting,
the servo deflexion will also be
increased.
• If the setting is decreased, the
servo deflexion will also be decre-
ased.
When adjusting, take special care that you do not set the servo to
full deflexion so that it is mechanically restricted. The servo could
be damaged. On the other hand, do not set the deflexion to low
so that the gyro is limited.
4.
Delay
Delay of the gyro can be set by the controller.
When using a digital servo, set the trimmer near ‚0’. If you use an
analogue servo, it is recommended to set the delay. Optimise your
settings for your system.
The absorption will decrease by turning your controller setting to-
wards zero, turning it towards 100 will result in higher absorption.
6.
LED
• LED off
on-board voltage turned off or
gyro not connected.
• LED constant light
The gyro is connected to the
controller
• LED blinking fast
After switching on, the gyro will initialise, the model and the
control levers on the transmitter should not be moved.
• LED blinking moderate
One of the levers or the models was moved during initialisation.
Switch off and retry.
• LED blinking slow
The gyro is not receiving a signal, the servo can not operate.
1
2
3