JAI TM-6740GE, Руководство по эксплуатации

Страница: 23 / 80

Page 11
Configuring the TM-6740GE Camera
TM-6740GE Software
FIGURE 10.
Camera Interface Application Dialog Box
To use the integrated GigE camera software, follow these steps:
1.
Start the Camera Interface Application. The dialog box shown in Figure 10 appears.
2.
Click the Detect button to detect the device and driver in the “Device Actions” panel.
3.
Click Select Camera and select TMTM-6740GE or TMC-6740GE (color) from the camera list.
4.
Select the “Acquisition” tab and click Configure . The camera configuration dialog box displays.
5.
Select the “GigE Camera Software” tab. This is the Integrated GigE Camera Software shown in
Figure 11 on the next page.
3.2 Configuring the Camera
To configure the TM-6740GE camera use the integrated GigE camera software that is part of the
Cam2Net camera interface application. You can also use the AccuPiXEL GigE control tool, but that
will not update any internal grabber settings. The “Hardware Introduction” section of this manual
contains a description of the different camera image settings.
Note that if you connect
the camera through a
network switch, you may
need to modify the
packet size.