PAIRING M.I.N.E.™ CAMERA TRANSMITTER TO CONTROL BOX RECEIVER
The most efficient way to pair M.I.N.E.™ Camera with control box receiver is to conduct these
steps before mounting camera in place.
THIS STEP IS ONLY A FUNCTION OF THE M.I.N.E.™ CAMERA. THE I.C.E.™ CAMERA DOES NOT UTILIZE
AN INTERNAL TRANSMITTER.
The M.I.N.E.™ Camera has an internal transmitter on the circuit board and must be located within 50 yards of the
M.I.N.E.™ Gate to operate correctly. Users must manually pair camera transmitter signal to each control box
receiver the first time they are linked together. It is not necessary to pair camera transmitter to receiver more
than one time.
Pressing and holding the Pair to Transmitter button for 8 seconds will clear out the memory.
11
Pairing Steps:
(New Receiver)
1. Press and release “frequency select” button (C) and red light (B) will flash either three times or five times.
Press and release “frequency select” button (C) until red light (B) only flashes three times.
2. Move camera selector switch from OFF to Setup.
3. Press and release “pair to transmitter” button (A) and red light (B) will illuminate for 15 seconds. Users only
have 15 seconds to complete step 4 once step 3 has been initiated.
4. Press and release camera “left arrow” (A) then press and release camera “right arrow” (B) to send a manual RF
signal to control box receiver. “RF Trigger” will appear at bottom of camera screen. Red receiver light (B) should
flash five times then no longer illuminate.
5. Ensure M.I.N.E.™ Camera and receiver are paired. Press and release camera “left arrow” (A) then press and
release camera “right arrow” (B) button while observing green light (D) illuminates. Test successful.
CRUSH HAZARD:
Stand clear of gate as it could cause bodily harm!
Ensure safety clip is installed if gate is in the UP position.
Pairing Steps:
(Old Receiver)
1. Move camera selector switch from OFF to SETUP.
2. Press and release “pair to transmitter” button (A) and red light (B) will illuminate for 15 seconds. Users only
have 15 seconds to complete step 3 once step 2 has been initiated.
3. Press and release camera “left arrow” (A) then press and release camera “right arrow” (B) to send a manual RF
signal to control box receiver. “RF Trigger” will appear at bottom of camera screen. The receiver light should
flash three times and shut off if performed correctly.
4. Ensure M.I.N.E.™ Camera and receiver are paired. Press and release camera “left arrow” (A) then press and
release camera “right arrow” (B) button while observing red light (B) illuminates. Test successful.
Repeat these steps on other control box receivers if multiple gates are used at trap enclosure.
A B
! WARNING
!
NOTICE
A
B
A
B
