Jäger Z33-D1100.01 S1, Руководство пользователя

Страница: 19 / 32

Commissioning
Item no. 10301064, Revision 08 19 ( 32 )
8.3 Compressed air
8.3.1 Air purity classes (ISO 8573-1)
Solid impurities
Class 3
Filter grade at least 5 µm for solids
Water content
Class 4
Max. pressure dew point +3 °C
Total oil content
Class 3
Max. oil content 1 mg/m
3
8.3.2 Setting values
For guidelines on air quality, see
"Air purity classes (ISO 8573-1)
[ } 19] " section.
Ü Keep to the following values:
Pneumatic system for tool change 6 bar
9 Commissioning
DANGER: Due to flying parts.
If the speed is selected incorrectly, the HF spindle or the tool may be de-
stroyed and their fragments may be flung out.
u Note the maximum speed for the selected tool.
u Note the maximum speed for the HF spindle.
u
Always select the lowest specified speed for machining.
Example of design: Inserting the
shank
Note: Ensure functionality.
u Never operate the HF spindle without a clamped tool shank.
If no tool shank is clamped:
q The clamping system is damaged by the centrifugal forces.
q
The clamping system is shifted.
q The balance of the HF spindle is affected.
q The bearing is damaged.
Example of design: Clockwise
Ü Turn the shaft of the spindle at least ten times by hand.