Jäger Z100-M636.03 S5V, Руководство пользователя

Страница: 31 / 40

Tool change
Item no. 10206006, Revision 03 31 ( 40 )
10.2 Manual hollow shank taper
1 Clamping segment
2 Access hole
3 Locking ring
4 Threaded spindle
5 Marking "X"
6 Snap ring
7 Ejector with withdrawal thread
8 Basic body
9 Driver
10 Cam
11
Shaft of HF spindle
12 Mounting spindle
Example of design: Joining position
Example of design: Clamping
position
Ü Turn the locking ring until the hexagon wrench can be guided axially
through the access hole to the hexagon socket of the mounting screw.
Ä Width across flats: 3
Ü
Turn the threaded spindle counterclockwise until you feel it reach the stop.
Ü Remove the hexagon wrench.
Ü Before inserting the tool mount into the HF spindle, clean the following:
Ä
Plane surfaces of tool mount
Ä
Taper of tool mount.
Ä Plane surfaces of shaft.
Ä Inner taper of shaft.
Ü Use the cleaning taper from the service set.
Ü
Insert the tool taper into the HF spindle.
Ä See figure: Joining position
Ü Insert the hexagon wrench into the threaded spindle through the access
hole.
Ü Tighten the threaded spindle clockwise with the tightening torque M
A
max.
Ä
M
A
max: 6 Nm
Ä
See figure: Clamping position