background image

1

INSTALL LAVATORY

FAUCET

Turn off hot and cold water

supplies before beginning.

CAUTION

Installation Instructions

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

  © J A D O   U S A   2 0 0 7

P r o d u c t s

L u x u r y   F a u c e t s   a n d   A c c e s s o r i e s

JADO USA
6615 West Boston
Chandler, AZ 85226
Phone:(800) 227-2734
Fax: (800) 552-JADO(5236)
www.jadousa.com

H 9 6 5 5 9 8

H 9 6 5 5 9 8

H 9 6 5 5 9 8

H 9 6 5 5 9 8

Single Lever Kitchen Faucet

Adjustable Wrench

Phillips Screwdriver

Channel Locks

Recommended Tools

Tubing Cutter

Regular Screwdriver

2

Product Numbers

831/800/...

Teflon Tape

WATER SUPPLY CONNECTIONS

Note: 

FLEXIBLE HOSES 

(1, 2)

 on FAUCET 

(3)

 are 18-1/2" (470mm)

in length from base of faucet. If longer supply length is required

installer must purchase adapters and additional supplies to

complete connections.

Important: If SUPPLY HOSES 

(1, 2)

 are to long, loop as

illustrated to avoid kinking.

Connection on FLEXIBLE HOSES 

(1, 2)

 is 3/8" compression. Connect

left supply marked (RED) to Hot and right supply marked (BLUE) to Cold wall supply.

Use adjustable wrenches to tighten connections. Do not

over tighten.

Complete all drain connections to sink and waste outlet.

1

1

3

2

COLD

HOT

HOSE LENGTH

3/8" COMPRESSION

ROUGHING-IN DIMENSIONS

Glance

GROOVE IN

(FAUCET BASE)

MOUNTING

SURFACE

3

2

1

4

10

5

6

7

8

COLD

(OFF)

(ON)

HOT

9

Seat O-RING 

(1)

 into under side of ESCUTCHEON RING 

(2)

.

Feed FAUCET SUPPLIES 

(10)

 through the mounting hole and 

install

the FAUCET 

(3)

 into in the sink or counter top.

 

Assemble the two BRASS SCREWS 

(4)

 into the RETAINING

LOCKNUT 

(5)

.

Assemble SUPPORT PLATE 

(6)

 with collar facing down onto SPOUT

SHANK (7). Assemble RUBBER WASHER (8), BRASS WASHER 

(9)

and RETAINING LOCKNUT 

(5)

 onto FAUCET SHANK 

(7)

 from

underside of sink or countertop.

Align and center FAUCET 

(3)

. Tighten LOCKNUT 

(5)

 on SHANK 

(7)

.

Tighten the two BRASS SCREWS 

(4)

 to secure FAUCET 

(3)

 to

mounting surface.

   

3a

CHECK DRAIN CONNECTIONS

Rotate STRAINER 

(3)

 and fill sink with water.

Rotate STRAINER 

(3) 

to drain water from sink.

Check all drain connections for leaks.

Tighten connections if necessary. 

3

TEST INSTALLED FAUCET

AND CHECK FOR LEAKS

With HANDLE 

(1)

 in OFF position, turn on WATER

SUPPLIES 

(3)

 and check connections for leaks.

Operate HANDLE 

(1)

 in all positions to flush water

lines thoroughly. Rotate SPOUT 

(4)

 from left to right.

Replace AERATOR 

(2)

.

HOT

3

2

COLD

3

1-1/2" D.

(38mm)

10"

(254mm)

18-1/2"

(470mm)

NOTE: Bore hole size is

1-3/8" (35mm)

1-1/4" D.

(33mm)

2"

(50mm)

6-3/8"

(162mm)

7-7/8"

(201mm)

7-7/8"

(201mm)

BLUE

RED

BLUE

RED

18-1/2"

(470mm)

Move HANDLE 

(1)

 to "off" position.Rotate AERATOR 

(2)

counter-clockwise and remove.

4

HELPFUL HINTS FOR CLEANING AND MAINTENANCE

The solid brass product you have just purchased has been designed to give you years of beauty and service. It is

important to bring to your attention proper care and maintenance procedures, which will ensure its lasting beauty.

First and foremost, it is important (as it is with any fine piece of jewelry or furniture) that the product be wiped clean and

dry with a soft damp cloth after every use.
Second, under no circumstances should an abrasive cleaner or combination cleaner/polish be used on JADO products.

The abrasive nature of such products will eventually destroy the finish and void the warranty.
In the event of stubborn blemishes shown on the finish, we recommend use of Windex window cleaner with a soft cloth,

but we do not recommend it be used on an everyday basis.
It is important to note that it is normal to expect signs of usage over time.

Thank you for selecting JADO for your home.

TO THE PURCHASER OF JADO BRASS PRODUCTS

Attention installer:

Please leave This Pamphlet for The Owner

POLISHED BRASS AND CUSTOM FINISH WARRANTY

: A 1 YEAR LIMITED FINISH WARRANTY from date of purchase is provided to the

first residential owner against defects in materials and workmanship.  Due to the ever-changing finish of Patina products, the finish warranty

is excluded.  Warranty shall not include problems related to the installation of the product.

MECHANICS

MECHANICAL WARRANTY: 

A LIFETIME LIMITED WARRANTY is provided to the first residential owner on parts to be free from failure

related to defects in materials and workmanship but not installation.

CONDITIONS TO WARRANTIES

JADO Bathroom & Hardware Manufacturing Corp. places the following conditions on its finish and mechanical warranties to the first residential owner only.

JADO finish and mechanical warranties are limited to products correctly installed and used in a residential environment.

JADO warranties will not assume liability for damage due to abuse, mishandling, incorrect installation, improper maintenance, or deterioration

due to normal use.

JADO will not be liable for labor or other costs relating to the sale, installation, or replacement of their products.

In the  event of a defect in any JADO product covered by this warranty, the product must be returned to the dealer where originally purchased

along with proof of purchase.

JADO's obligation under the warranty shall be limited to the repair or exchange of any product which has been determined by JADO to be

defective after appropriate examination.

The  state  of  California  has  mandated  under  Proposition  #65  that 
manufactures  of  products,  including  faucets  which  come  into 
contact with potable water, must warn the consumer if the product 
contains  materials  listed  by  the  state  as  a  carcinogen  or 
reproductive toxin.  Lead, which is contained in all brass faucets in 
limited amounts appears on the State's list.

Preliminary  industry  tests  have  indicated  that  users  of  faucets 
made from brass face no significant danger, however,
California Proposition #65 requires that we  provide you with the 
following notice:

NOTICE:  JADO  products  conform  to  industry 
requirements  of  water  conservation  under  the 
ASTM  /  ANSI    A112.18.1M-1994    plumbing  code.   
Lavatory,  bidet,  wet  bar  and  kitchen  faucet  sets 
have  a  maximum  flow  rate  of  2.2GPM.    Shower 
heads,  hand  showers  and  body  sprays  have  a 
maximum flow rate of 2.5GPM.

Warning:  This product contains an element 

known to the State of California to cause cancer

of reproductive harm.

JADO BATHROOM AND HARDWARE MFG. CORP.

6615 West Boston

Chandler, AZ 85226

 

  JADO warrants this product to be free from defects in materials or workmanship for as long as the original consumer purchaser

owns their home.

  JADO will provide, free of charge, at it’s sole option, replacement part(s) or product (or if no longer available, a comparable

product) to replace those which have proven defective in materials or workmanship.

  Proof of purchase (original sales receipt) from the original consumer purchaser must be made available to JADO for all limited

warranty claims. This limited warranty is non transferable. It does not apply in the event of product damage due to the use of other than

genuine JADO replacement parts, installation error, abuse, misuse, or improper care and maintenance (whether performed by

a plumber, contractor, service provider or member of the purchaser’s household). The limited warranty excludes damage due to aggressive

air or water conditions, or harsh or abrasive cleaners and/or materials. This limited warranty excludes all industrial, commercial and business

usage, whose purchasers are hereby extended a two year limited warranty (with the exception of solenoid valves and other electronic

components which carry a one year limited warranty) applying to all other terms of this limited warranty except duration. This limited warranty

does not cover labor charges incurred and/or damages sustained in installation, repair or replacement, nor incidental or consequential

damages, all of which are expressly disclaimed. This limited warranty is applicable only to JADO faucets manufactured after June 1, 1996

and installed in the United States and/or Canada.

  This limited warranty gives the original consumer purchaser of an JADO faucet specific legal rights which may vary from state to

state or from province to province. This limited warranty does not cover any liability for consequential or incidental damages, all of which

are hereby expressly disclaimed, or the extension beyond the duration of this limited warranty of any implied limited warranties, including

those of merchantability or fitness for an intended purpose. In some states or provinces the exclusion or limitation of incidental or consequential

damages is not allowed, so those exclusions may not apply to you.

JADO Bathroom & Hardware Manufacturing Corp. provides the following warranties only to the first  residential owner of our products.

FINISHES  

JADO FAUCET LIFETIME FUNCTION AND FINISH LIMITED WARRANTY

3/8" COMPRESSION

Note: Drain not included with fitting and must be

purchased separately. 

Отзывы: