P/N 2411600000 Rev. D 07/2011
Page 5
For model
JGTSD
, turn on the main valve at the rear and rapidly rotate igniter knob. A multiple clicking should
be heard from the igniter indicating a spark is being provided to the pilot. When the pilots are lit, turn on the
red valve handle in front and set the thermostat to the desired temperature.
For
JGTSDS
models, a safety valve is provided, so gas will not flow to the pilots and main burners until the
pilot is lit. Light the pilot with the piezo igniter as in the
JGTSD
model. When the pilot is lit, set the thermostat
to the desired temperature.
A pilot valve is provided for
JTYG
Models
:
1. Turn burner control knob to “OFF” Wait 5 minutes.
2. Push and hold down the red button on the pilot valve to light the pilot. Continue to hold down the red
button for a minimum 30 seconds until the pilot light remains on. Release red button.
3. Turn burner control knob on.
4. Check if pilot flame thru hole on front panel. If extinguished, repeat Steps 1 to 3 above.
5. Turn burner control knob to “OFF”.
