9
INSTALLATION
Installation must be performed in accordance with all Local NEC codes.
Preparing the Pool Water:
Check the pool water chemistry and balance BEFORE activating the salt chlorinator. It is recommended that you
consult a pool professional for the initial water balancing each season.
NOTE:
At the beginning of each season, add metal remover and polymer based (non copper) algaecide to the pool, as
per the manufacturer’s instructions. This operation will ensures a rapid, trouble free transfer to the SANICLEAR
chlorine generation system.
The SANICLEAR control panel is suitable for outdoor mounting. It must be installed a minimum of 5 ft. (1,5 meters)
of distance (or more depending on local codes requirements) from the pool or spa.
The control of the SANICLEAR control box is designed to be mounted in a vertical position on a flat surface with the
pre-punched holes downwardly facing. Because the case also used to disperse the heat, it is very important that the four
sides of the control are not blocked to serve as ventilation openings.
Do not mount the case in a closed panel or confined area.
Make sure the salt chlorinator installation does not interfere with the potable water connection. Verify local plumbing
codes.
The switches (cell and flow) are connected in the return line to the pool. They are installed after all the other pool
equipment like filter, heater, solar, etc. The necessary plumbing components are provided
Refer to the diagram on next page for plumbing:
When you install the flow switch
insure that the position of the arrow on the flow switch (located on top) is in the
same direction of water flow. See below drawing.
Use the unions provided and tighten by hand at both ends of the cell for a perfect watertight seal. For pool or spa with
spillover systems, use the fig #2 or #3 below to allow that chlorination is functional for both the pool and spa during
spillover but when using the spa only it will prevent over chlorination.
Содержание SANICLEAR10
Страница 10: ...10...
