TIPS FOR USAGE
ASSEMBLY INSTRUCTIONS
This pool cleaner was made to assist you in keeping your pool clean and
well maintained. Here are ten important tips:
1. Once installed, your cleaner is designed to run for 4-6 hours and should
be able to clean an average sized pool in that time.
2. Your pool needs to be in good condition in order to use this cleaner. If
there are broken tiles or plaster, or tears in the vinyl, the cleaner may
damage your pool further.
3. The cleaner is not designed to clean pool features, waterfalls, steps or
ladders. Those will need to be cleaned manually with a brush.
4. The cleaner is not designed to run and clean under a solar cover.
5. Run your cleaner 2-3 times a week.
6. Do not wait until your pool is filthy to run the cleaner. The cleaner should
be considered a preventative maintenance for a clean pool.
7. The cleaner is meant to vacuum small debris and dirt from your pool.
Large debris and fallen objects will need to be removed manually.
8. This cleaner is not meant to replace chemical treatments. Continue
chemical treatments; remove the cleaner during shock treatments.
9. Before swimmers enter the pool, turn off the pump, unplug the hose,
cover the intake, and then move the cleaner and hose to an unused side
of the pool.
10. Your cleaner should stay in the pool at all times,
EXCEPT
when it may
endanger swimmers. Dry storage will wear the cleaner/hose more quickly
than storage in a correctly balanced pool.
CLEANER ASSEMBLY
1.
2.
3. Attach the
bumper ring (#2)
by pushing the flanged end of the
hose
connector (#1)
onto the top hose opening of the cleaner body.
3
4
Attach the
finned disc (#11)
to the bottom lip of the cleaner by sliding it
around and over the lipped circular opening. The word
“TOP”
should be facing op-
posite the floor. The finned disc should spin freely after it is attached.
If not already installed, insert the long tube, ring, and diaphragm
(#13, #14,
and
#15)
assembly into the center of the cleaner with the yellow diaphragm
towards the bottom of the cleaner.
